2008 KAWASAKI NINJA 650R OWNERS MANUAL PDF

EvilTwin’s Avatar. Join Date: Oct Location: Orange, CA. Posts: 5, I Ride : Versys. Kawasaki Ninja R Service Manual. ninja r owners manual kawasaki ninja r owners manual chasing ninja r owners manual ninja r owners pdf the kawasaki zx6. DOWNLOAD KAWASAKI NINJA R OWNERS MANUAL. kawasaki ninja r pdf. The Kawasaki Ninja R, also called ER-6f or EÐ¥-6, is a.

Author: Macage Danos
Country: Ecuador
Language: English (Spanish)
Genre: Spiritual
Published (Last): 12 September 2011
Pages: 351
PDF File Size: 1.60 Mb
ePub File Size: 6.76 Mb
ISBN: 689-6-17415-199-6
Downloads: 58783
Price: Free* [*Free Regsitration Required]
Uploader: Molrajas

Right Switch Housing Lead 6.

Before replacing a blown fuse, always check the amperage in the affected circuit. Clamp Install the clamp with the quick rivet onto the throttle body assy.

If bearing play, roughness, or binding is found, replace the bearing. Page Apply silicone sealant to the portions 605r on the upper crankcase half, and insert [F] the new oil plug until it is bottomed. Overall Width mm Page After measurement, remove the needle adapters and ap- ply silicone sealant to the seals [A] of the connector [B] for waterproofing.

Therefore the cutter must not be used for other purposes than seat repair.

Starter Relay Lead 4. Meter Unit Connector Cover the connector with the cap securely. Newly activated sealed batteries require an initial charge. Insert the clamp into the frame from the air cleaner side.

  ITEXT XFA TO PDF

Download Manual: 2008 Kawasaki Ninja 650R — Owner’s Manual

The starter motor clutch gear should turn clockwise [B] freely, but should not turn counterclockwise [C]. Windshield see Windshield Removal in the Frame chapter. ECU Main Relay Subthrottle Valve Actuator http: Clamp Hold the main harness, and insert the clamp into the battery case. Torque – Water Pump Cover Bolts: Run the frame ground lead ownerw outside of the other leads.

Kawasaki Ninja R – Owner’s Manual – Pages – PDF

Note the fol- lowing. Water-proof Joint D 3. Environment when problem occurred. Inlet Air Temperature Sensor Bands Hold the main harness between the frame pipe and fuel tank bracket.

Water-proof Joint C 3. Then tighten them according to the specified se- quence to prevent case warpage or deformation which can lead to malfunction. Water-proof Joint A 6. Sealant – Three Bond: Illustrations and photographs in this publication are intended for reference use only and may not depict actual model component parts. Standard Atmospheric Pressure Absolute Pv: Circlip [D] 25 mm 0. Special Tool and Sealant If they are badly worn or if there are groove cuts where the tangs hit, replace the housing.

Pull the bulb out to prevent damage to the bulb. Only appropriate permanent internal repairs are recommended.

  DEONTOLOGIJA MEDIJA PDF

Owner’s Manuals & Service Manuals | Kawasaki Vehicles

Do not use bulb rated for greater wattage then the specified valve. Service Code 51, 52 Stick Coil Circuit 1. Friction Plate Warp 0. Battery Negative — Lead Connector 3. Then push and turn it further in the same direction and ,awasaki the cap.

How can cool down for engine heated? Battery 12 V10 Ah 9.

Kawasaki Ninja 650R Service Manual

The push rod does not return to its original position once it moves out to take up camshaft chain slack. Engine Stop Switch 3. Bearing Remover Shaft, Removal may damage them. Main Fuse 30 A 8. Rear Wheel Rotation Sensor 2.

Front Brake Light Switch If the fan kawaeaki not rotate, the fan motor is defective and must be replaced. If the indicator light lights, remedy the problem and clear the service code.

Valve Seat Cutter Holder Bar: Throttle Cable Decelerator 2. Turn the ignition switch OFF. Tighten the two clamp bolts alternately two times to ensure even maual torque.